When people hear “commercial chiller installation,” they picture weeks of disruption, complicated coordination, and expensive headaches.
In reality, it’s like installing a hot water system.
Three main steps:
Let me walk you through it with a Bergs split system design.
Step 1: Position the Units
The outdoor unit goes on the roof or just outside your building. The indoor unit goes in your plant room or near the baths.
Once they’re in position, pipes connect the two units, and power gets hooked up. This needs a refrigeration mechanic and an electrician, but here’s the thing: we use Australian standard components. Any qualified refrigeration mechanic and electrician in Australia can handle this work.
You can use tradespeople you already know and trust, or we’ll connect you with our trusted partners.
Step 2: Connect the Water
A plumber or pool tech connects the water pipes between the chiller and your tubs, including any filtration systems you have.
Common Question: Do I need a massive filtration system at the same time?
Short answer: No, you don’t have to.
That said, we recommend it for easier management, local compliance, and customer safety—but it’s your call.
Step 3: Commission
Water goes in. The refrigeration mechanic “commissions” the system—they turn it on, verify everything’s running smoothly, and confirm it’s pulling temperature from the baths like it should.
Done.
After Installation
The chiller runs automatically. You don’t need to check it.
Every six months, schedule a basic service to keep the coils clean and everything running efficiently.
Is it more work than a portable unit?
Yes, initially.
But once it’s in, the work stops.
No ice runs.
No babysitting a temperamental machine.
No noise filling your recovery space.
No panic when it can’t hold temperature during your busiest time.
Just consistent, reliable cold water.
The installation takes a couple of days.
The peace of mind lasts years.